Canada
United States / International
Shop your site for local pricing and availability.
We offer replacement marking gauge cutters without rods for all of our marking gauges. While you will probably never wear out a marking gauge cutter, it is common to chip or break a cutter through use or by dropping your marking gauge.
Our marking gauge cutters are designed to work with either a Cosmanized or a Rob Cosman marking gauge rod but they may fit any marking gauge rod that attaches the cutter with a 6-32 inch or 4mm threaded screww, but we cannot guarentee that.
All of our cutters come pre-sharpened. We sharpen these on a CBN abbrasive wheel.
We offer four different sizes of replacement marking gauge cutters without rods. Each cutter is a different size and has different bevel angles so that you can use the right cutter for the right job. See below for details:
3/8 inch cutter with rod - 40 degree bevel (Best used for cleaning out mortises and sockets). Cutter only fits a 6-32 inch threaded screw.
1/2 inch cutter with rod - 25 degree bevel (Best used as a general purpose cutter in soft or hard woods). Cutter fits both a 6/32 inch threaded screw and a 4 mm threaded screw.
7/16 inch cutter with rod - 20 degree bevel (Best used for marking in soft woods). Cutter fits a 6/32 inch threaded screw or a 4 mm threaded screw.
5/8 inch cutter with rod - 35 degree bevel (Best use when marking for angled dovetails). Cutter fits a 6/32 inch threaded screw or a 4 mm threaded screw.
